Long Radius, 90° Fitting

NOTE: Use the Fittings Calculator to determine total amount of hardware required for your fittings.

1. CUT THE BOTTOM AND SIDE WIRES
To form 90° bends in the tray, cut out the number of sections shown below based on the width of the tray used.

2. ASSEMBLE USING APPROPRIATE HARDWARE
Standard hardware is shown with each bend size.

Advantages:

  • Use as bonding jumper

  • Vertical support of standing sections

  • Adjustable radius allowances

NOTE: Always place nut on outside of tray

 
Long-Radius-90-1
Long-Radius-90-2
Long-Radius-90-3
Long-Radius-90-4